Why this one
01
Integrated light ring
Grazing light shows scratches and unevenness while sanding.
02
Brushless EC-TEC II
Quiet, low-maintenance drive at 6,000–10,000 orbits per minute.
03
Vibration protection
3.5 m/s² and automatic slowdown if vibration rises.
04
Bag or extractor
Chip bag for mobile work, CLEANTEC connection for dust-free sanding.
The story
Finish sanding without a cable
The ETSC 2 150 is for painters, decorators and joiners who sand doors, frames, furniture and filled patches where a mains cable or hose gets in the way. It is held in one hand directly over the pad, low enough to control on edges and in narrow spots, and its 3.5 mm stroke leaves a fine surface for paint or oil.
Light and vibration control
A ring of LEDs around the pad throws low-angle light across the surface; it has full, dimmed and off modes, and the app allows finer dimming and afterglow time. Vibration protection cuts the speed if the tool starts to shake, and a carbide-tipped pad brake stops the pad spinning up when set down.
Works with or without extraction
Turbo extraction feeds a long-life chip bag for work away from an extractor, or connects to a CLEANTEC unit that starts via the Bluetooth battery. The pad uses StickFix abrasives and MULTI-JETSTREAM 2 hole pattern. The Basic version ships bare with Protector and chip bag in a Systainer³ SYS3 M 187.
Specifications
Grinding, cutting & sanding
- Sanding pad diameterEF003617
- 150mm
- Sanding orbitEF002847
- 3.5mm
- No-load speedEF008590
- 10,0001/min
- Brake
- ✓ Yes
- Soft start
- — No
- Kickback stop
- — No
- Paddle switch
- — No
