Why this one
01
230 Nm torque
Drives long structural screws and coach bolts without pre-drilling in softwood.
02
113 mm head
Compact head length for work between joists and inside cabinets.
03
5 speeds, 3 modes
Speed and screw mode set directly on the tool housing.
04
EXPERT class
Part of the 2025 top tier above the PRO range.
The story
Who it's for
Carpenters, decking and roofing crews, and steel fixers who drive long structural screws and coach bolts. 230 Nm and 4,000 impacts per minute sink large fasteners quickly, while the short 113 mm head gets between joists and into cabinets where longer drivers do not fit.
Control on the tool
Five speed settings run from 800 to 3,400 rpm, and three screw modes are chosen on the housing, no phone required. Bit insertion works one-handed through the 1/4" hex holder, which helps when you are holding the workpiece with the other hand.
Where it sits
EXDR18V-230 belongs to the 2025 EXPERT tier above the PRO range. It uses a standard brushless motor rather than BITURBO, runs on every Bosch 18V and AMPShare pack, and ships in an L-BOXX with a tool inlay. Pair it with a compact pack to keep the weight low for overhead work.
Specifications
Drilling & driving
- Torque, hard jointEF002842
- 230Nm
- No-load speed, gear 1EF011125
- 3,4001/min
- Impact rateEF004984
- 4,0001/min
- Torque settings
- 5
- Tool holderEF002843
- ¼″ hex
- Hammer mode
- — No
- Kickback control
