Why this one
01
610 mm rip capacity
Rack-and-pinion fence, 318 mm to the left.
02
Runs on FLEXVOLT
About 92 m of 19 mm OSB per 6 Ah battery.
03
65 mm cutting depth
45 mm at 45° bevel.
04
Steel roll cage
Protects the saw in transport and on site.
The story
Ripping where there is no power
Carpenters working on roofs, lofts and early-stage new builds often need to rip battens, fillets and sheet strips before temporary power is installed. The DCS7485 brings a real table saw to those places: a 210 mm blade cutting 65 mm deep, with DeWalt quoting 92 m of 19 mm OSB per 6 Ah FLEXVOLT pack.
Proper table-saw features
The rack-and-pinion fence moves parallel for accurate rips up to 610 mm right and 318 mm left, and the blade bevels to 45°. A cast table top stays flat, and the steel roll cage protects the saw when it is thrown in a van or dropped onto a scaffold deck. A push stick, mitre gauge and dust adaptor are included.
Shares batteries with the site
It runs on the same FLEXVOLT packs as the mitre saw, SDS hammers and extractor, so a crew can go fully cordless. Since a table saw is usually needed for short phases, it is also available from our rental fleet.
Specifications
Sawing
- Blade diameterEF002855
- 210mm
- ArborEF002856
- 30mm
- Cutting depth at 90°EF002849
- 65mm
- Cutting depth at 45°EF002850
- 45mm
- Max. bevel angleEF004988
- 45°
- Rip capacity
- 610mm
- No-load speedEF008538
