Why this one
01
Four-speed gearbox
500 to 3,600 rpm with direct shifting between any two gears.
02
KickbackStop
Electronics stop the drive if the bit jams.
03
75 Nm torque
Brushless EC-TEC motor, 70 mm in wood, for large screws and bits.
04
Percussion mode
Drills masonry up to 10 mm diameter.
05
FastFix attachments
Chucks and angle head change without tools.
The story
For big screws and big bits
The TPC 18/4 suits carpenters and installers who drive 8–10 mm screws, bore with augers and Forstner bits, and still need a quick hole in brick now and then. First gear handles demanding screws up to 10 mm, second drives 8 × 300 mm screws, and fourth runs small bits at 3,600 rpm. Gears can be changed directly without passing through the others.
Safety built in
If a bit jams, the electronic KickbackStop cuts the drive before the handle twists the wrist. The brushless EC-TEC motor and four-speed metal gearbox give 75 Nm on hard joints and 70 mm in wood. With a Bluetooth pack, the Festool app sets the LED light, reverses the switch for left-handers and shows operating data.
Part of the 18V system
Like the smaller drills it has a FastFix spindle, so the MMFP 13 mm chuck, CENTROTEC chuck and the AN-UNI angle head all fit. It runs on any Festool 18V pack. The Basic version comes with an auxiliary handle and belt clip in a Systainer³ SYS3 M 187; the sets add attachments or batteries.
Specifications
Drilling & driving
- Torque, hard jointEF002842
- 75Nm
- Torque, soft joint
- 50Nm
- No-load speed, gear 1EF011125
- 5001/min
- No-load speed, top gear
- 8001/min
- Impact rateEF004984
- 57,6001/min
- Gears
- 4
- Tool holderEF002843
- Interchangeable chuck system
